tag:blogger.com,1999:blog-5415584649217620448.post6511692466118878281..comments2021-07-09T05:43:57.405-07:00Mikehttp://www.blogger.com/profile/17227485615141686252noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-5415584649217620448.post-65246531200949477232021-03-14T14:55:43.812-07:002021-03-14T14:55:43.812-07:00Turn signal housing is still wired up to bars, so will be more difficult. Are there any specific tweezers that can be used to compress the spring and the sliding U shaped contact that will mate with the contact feature of the wire harness and also then assemble the spring and detent ball into the other side of the black slider component and then while keeping the ball detent and sliding contact compressedAnonymoushttps://www.blogger.com/profile/09170087864530086435noreply@blogger.comtag:blogger.com,1999:blog-5415584649217620448.post-25772640125785458322020-10-03T12:57:02.224-07:002020-10-03T12:57:02.224-07:00Great info thanks much.Anonymoushttps://www.blogger.com/profile/05375970940875894072noreply@blogger.comtag:blogger.com,1999:blog-5415584649217620448.post-67872540076741742752020-06-13T08:47:49.802-07:002020-06-13T08:47:49.802-07:00Thanks! Today's project is a new button, spring, and horn on my 1974 CT90!jjmIIIhttps://www.blogger.com/profile/00596747160889974269noreply@blogger.com